GCC 표준 지도

1.1 This specification covers high-strength low-alloy structural steel shapes, plates, and bars for welded, riveted, or bolted construction but inten…

1.1 This specification covers uncoated, high-strength, harddrawn steel wire for use in the construction of prestressed concrete tanks and similar str…

1.1 This specification covers plain and deformed steel wire and plain and deformed steel welded wire reinforcement with protective epoxy coating. A Cl…

1.1 This specification covers two types and two grades of indented seven-wire uncoated, steel strand for use in prestressed concrete construction. The…

1.1 This specification covers hubless cast iron soil pipe and fittings for use in gravity flow applications. It establishes standards covering materia…

.1 This specification covers high-strength low-alloy structural steel shapes in Grades 50 [345], 60 [415], 65 [450], 70 [485], and 80 [550], produced…

1.1 This specification establishes requirements for sand castings produced from copper-base alloys having the alloy numbers,2 commercial designations,…

1.1 This specification establishes the requirements for seamless copper water tube suitable for general plumbing, similar applications for the convey…

1.1 This specification covers woven wire plaster base, flat or self-furring, with or without stiffener wires, and with or without factory-attached wat…

1.1 This practice covers a technique for using heat flux transducers (HFTs) and temperature transducers (TTs) in measurements of the in-situ dynamic o…

1.1 This test method covers the determination of the structural performance of dimension stone cladding systems under positive and negative uniform s…

1.1 This test method provides procedures for the sampling and analysis of hydraulic-cement mortar or concrete for chloride that is water soluble under…

1.1 This specification covers structural clay load-bearing facing tile and facing brick and other “solid masonry units” made from clay, shale, fire-cl…

1.1 This specification covers sampling; inspection; rejection; certification; packaging and marking; and shipping, handling, and storage of gypsum pa…

1.1 This specification provides requirements for membraneforming liquids suitable for use as curing compounds and sealers on freshly placed concrete …

1.1 This specification includes the physical properties, sampling, testing, tolerance, and appearance requirements for architectural cast stone. 1.2 C…

1.1 This specification covers brick, having a ceramic glaze finish fused to the body during the same process as the unit body firing, that are intende…

1.1 This test method covers a technique for determining the solar reflectance of flat opaque materials in a laboratory or in the field using a commerc…

1.1 This guide covers information on selection of insulation materials, systems design, application methods, protective coverings, guarantees, inspect…

1.1 This guide is intended to provide a technical approach to the evaluation of alternative supplementary cementitious materials such as pozzolans an…

1.1 These test methods evaluate the performance of vertical wall applications of non metallic plaster bases used with Portland cement based plaster un…

1. Scope 1.1 This specification applies to the minimum installation requirements for non metallic plaster bases used with Portland cement based plaste…

1.1 This specification provides the minimum specification for use of non metallic plaster bases with Portland cement based plaster in vertical wall ap…

1.1 This specification covers fly ash brick intended for use in masonry, which are made from fly ash, water, and suitable mineral aggregates with or w…

1.1 This specification covers ground-glass pozzolans for use in concrete where pozzolanic action is desired. This specification applies to ground gla…

1.1 This guide provides guidance for the handling, physical condition and compositional considerations for selecting scrap gypsum panel products and t…

1.1 This test method covers determination of the air content of freshly mixed concrete from observation of the change in volume of concrete with a cha…

1.1 This practice covers procedures for making and curing cylinder and beam specimens from representative samples of fresh concrete for a construction…