GCC 표준 지도

This part of IEC 61400 provides guidance on principles which can be used as the basis for determining the application, structure and recommendations f…

This part of IEC 61858 provides information on the identification of electrical insulating materials and auxiliary components for the assessment of mo…

This document refers to high-voltage / low-voltage prefabricated substations (hereinafter prefabricated substations) as specified in IEC 62271-202:201…

This part of IEC 62829, which is a Technical Report, covers • a study into the pre-requisites of chemometric (exploratory) data analysis, • an overvie…

This Technical Report, which is informative in its nature, describes common practices and state of the art for renewable energy power forecasting tech…

This document, which is a technical report, sets out a uniform calculation method for the parameter of adjusted volume that is commonly employed in th…

This document, which is a Technical Report, is intended for use as guidance for reducing fire risks in general and for site-specific needs for buildin…

This Technical Report deals with the determination of repeatability and reproducibility of test methods used for assessing the performance characteris…

This part of IEC 62257 provides baseline requirements for quality, durability and truth in advertising to protect consumers of off-grid renewable ener…

This document provides design requirements to ensure the engineering integrity of wave, ocean, tidal and river current energy converters, collectively…

This part of IEC 62600 establishes general principles for design assessment of OTEC plants. The goal is to describe the design and assessment requirem…

This part of IEC 62600 includes: • definition and specification of the quantities to be determined for characterizing the power quality of a marine en…

This part of IEC 62600 specifies the requirements of the technology qualification process for marine renewable technologies. Technology Qualification …

This part of IEC TS 62788 provides guidelines to assess the ability of an edge seal to prevent moisture ingress from the edges of PV modules. This doc…

The purpose of this document is to provide guidelines for operation of microgrids. Microgrids considered in this document are alternating current (AC)…

The purpose of this part of IEC 62898 is to provide guidelines for the specification of fault protection and dynamic control in microgrids. Protection…

This part of IEC 63042, which is a technical specification, applies to on-site acceptance tests of electrical equipment with the highest voltages of A…

This document applies to docking connectors (hereinafter referred to as accessories) incorporated in or fixed to electrical equipment, intended to con…

This document defines additional testing requirements for modules deployed under conditions leading to higher module temperature which are beyond the …

This document provides test methods for quantifying the permanent change in a monolithically integrated PV module’s power output that may result from …

This document describes the procedure for evaluating the energy conversion performance of stand-alone or grid-connected power conversion equipment (PC…

This document is intended to apply to terrestrial modules for consumer applications for outdoor operation shorter than those qualified to IEC 61215. T…

This document is intended to provide information to supplement the baseline testing defined in IEC 61215, which is a qualification test with pass-fail…

This document gives guidance for the development and maintenance of the documented information necessary to support an effective quality management sy…

This document gives guidelines for realizing financial and economic benefits by applying a top-down structured approach to achieving financial and eco…

This document gives guidelines for an organization to establish, implement, maintain and improve systems for competence management and people developm…

This document gives guidelines for the selection of appropriate statistical techniques that can be useful to an organization, irrespective of size or …

This document specifies the overall length and the maximum head thickness for double-headed openended engineers' wrenches. NOTE The wrenches covered …

This document specifies the overall length and the maximum head thickness for double-headed box wrenches, flat (Form B) and offset (Form A). NOTE The …

This document specifies the overall length and the maximum head thickness for double-headed box wrenches, deep offset (Form B) and modified offset (Fo…